Square luminaire for installation in wall and ground – recessed.
Configuration: die-cast aluminium structure, EN AB-47100 alloy (low copper content). Glass diffuser fixed to the aluminium body through a robotic gluing system.
Double layer coating for high resistance to corrosion: the aluminium components are painted with a double coat using powders which are compliant with QUALICOAT standards: a first layer of epoxy powder (with excellent chemical and mechanical resistance) and a second finishing layer of polyester powder (resistant to UV rays and atmospheric agents). The entire painting process of the aluminium fitting starts from components which have been sandblasted in advance to make the surface more porous and increase the adherence of the paint. Ares effects alkaline and acid washing to clean the surfaces completely, then rinses with demineralised water to remove any residue particles, subsequently a chemical conversion treatment is done to protect against rusting.
Protection rating: IP67
In compliance with EN 60598-1 standards
Class of insulation: III
Installation: the luminaire is equipped with 300mm of cable for a quick connection. K12 Power LED is equipped with a dc/dc highly efficient converter that removes electromagnetic interference and allows parallel wiring. The whole range is protected against polarity reversal and sudden voltage peak. Outdoor use requires suitable flexible cables. Installation requires a dedicated box to be ordered separately. It is important to provide a >200mm gravel layer or a drain system (for concrete surface) to ensure good drainage and to avoid water stagnation.
We recommend the use of a connection system with a protection degree greater than or equal to the protection degree of the luminaire.
During the installation and the maintenance of the fixtures it is important to be careful and avoid damages on the paint coating.
Damages on the coating exposed to outdoor conditions or water, could cause corrosion.
Chemical substances affect the anticorrosion covering protection.
- Power (W): 7.5
- System power (W): 8
- CRI: 80
- Mountings: Ground recessed, Wall recessed
- Environment: Outdoor wet location
- Lighting type: Direct
- LED type: Power LED
- Light distribution: Symmetric
- Optical type: Diffused light
- Frequency (Hz): 50-60
- Voltage (V): 24
- Dimmable: Yes
- Driver type: Dimmable DMX
- Emergency: Without
- Insulation class: III
This data is not currently available for this product
Box for Installation K12Ln
- Item Code: 183
Suction Cup K12
- Item Code: 153
Dmx Controller Dimmer Switch For Recessed Box
- Item Code: 142
Dmx Controller Stand-Alone/Pc Interface
- Item Code: 143
Dmx Cable Shielded Twisted Pair
- Item Code: 186
DMX splitter 512 - electronic device to regenerate the monodirectional DMX signal 1 Input and 7 output, 12-24Vdc_IP20. Power supply not included
- Item Code: 187