Dimensions
- Weight (kg)
- 1.35
- Width (mm)
- 80
- Length (mm)
- 120
- Height (mm)
- 175
Main features
- Item code
- F1111U18
- EAN
- 8054793559377
- Construction material
- ALUMINIUM/GLASS
- Environment
- Outdoor wet location
- Mounting
- Wall
-
Forward voltage (V)
Main features
Main featuresThe voltage required for an LED to operate properly, measured in volts (V). This can vary depending on the type of LED.
- 100-120
- CCT (K)
-
2700
-
IP rating
Main features
Main featuresTells you how well the lamp is protected against dust and water. A higher number means better protection.
- 65
-
Light source type
Main features
Main featuresIndicates whether the lamp uses a traditional bulb or an LED light source.
- LED
-
LED type
Main features
Main featuresIndicates the type of LED used (e.g. COB, SMD or filament), which affects brightness, energy use and the look of your lamp.
- Power LED
-
Number of lamps
Main features
Main featuresSpecifies how many light sources a fixture requires or includes, affecting brightness, light distribution and aesthetics.
- 1
- Energy label
- E
- Light source replaceable
-
Non-replaceable light source
-
Certifications
Power supply and control
- Driver
-
Integrated
Power supply and control
Power supply and controlDriver is built into the lamp.
-
Dimmable
Power supply and control
Power supply and controlTells you if the brightness can be adjusted with a dimmer switch.
- No
- Dimming interface
- Not Dimmable
- Power supply replaceable
-
Replaceable control gear by a professional
Driver
Additional Information
We recommend using a connection system with a degree of protection greater than or equal to the degree of protection of the luminaire. During the installation and the maintenance of the fixtures it is important to be careful and avoid damages on the paint coating. Damages on the coating exposed to outdoor conditions or water, could cause corrosion. Chemical substances affect the anticorrosion covering protection. For LED fixtures, there is evidence that most of the damages are connected to electrical effects related to the insulations, which cause destructive electrical discharges These effects are frequently caused by: • over voltage coming from the mains’ network where fixture is connected. • electrostatic discharge (ESD) coming from the environment. The use of a protective device against the overvoltage on the electrical installation is warmly suggest this helps to reduce the intensity of some of these phenomenon and prevent irreversible damages. The selection of the type of device to be used must be adjust on the electrical plant.
Do you want to discover more?
